Climate Solutions Community

Hallo Herr Schneider, Wir haben ein  Vitocal 200-S AWB-E-AC 201.D16 (5,5 - 14,7 kWH) und auch ein solar anlage welche die Smart Grid modus schalted. Wie kann die "Netz Begrenzer" damit zusammen funktionieren ? Wann Ich genug Solar Produktion habe und auf gleiche moment shaltet die begrenzer zuruck nach 4,7 kWH...wass passiert dann ? Bedeuted dass Ich nicht meine Solar Produktion frei benutzen kann ? Oder begrenst er nur die Netz verbinding nach ausen, egal welche gerät strohm benutzt ? ... Mehr anzeigen

Hello Flo, my number  is 7733738304591121 ... Mehr anzeigen

Ok, I think I understand:  in my situation I can see that my Heatpump circuit does not get higher 62 Celcius and then it stops. As a result my heating water reaches 55 Celcius and my Warm Drinkwater to 49 Celcius. That is then my max ?  Do you have tips for me so that i can heat even more than this ? I have still a lot of Solar "Uberschuss" 🙂   Thanks a lot ! ... Mehr anzeigen

Hallo Herr Schneider,   Thanks for your quick response. No, the pump was not running when I took the picture, only function 3, SG ready was activated.   I have no auxiliary heater installed to my knowledge. I only have the SG ready function activated. Do I understand correctly that in my situation it is not possible to heat up to 60 celcius for warm water via function 3 ?   ... Mehr anzeigen

Hallo Herr Schneider,    I am coming back to you again to follow -up on my question above where I am wondering why my heatpump does not get triggered and does not heat up to the higher temperatures. See the system overview pictures. Can zou explain ? ... Mehr anzeigen

Hello Herr Schneider,   Meanwhile i have set-up the Smart grid connection and it is also active (see my screenshot) . But the heatpump does NOT get triggered to start heating the higher temp in the WarmWater Storage. I have done the 10 K increase in the Smart Grid menu. Is there more I need to do ?     ... Mehr anzeigen

Hallo Herr Schneider,   I have a VITOCALL 200S system  and a Fronius GEN 24 Inverter. And I have this small connection schema from Fronius :   Can you advise which connectors represent the "K4" and "K3" boxes (circled on the picture below) on the Viessmann connection board ? Perhaps the : 216.1 (B) or 216.4 (A) ?   And if so does this mean , I only have to connection a small wire between the relaix and and the Viessmann board ? Like in the attached schema ?   ... Mehr anzeigen